29-12-2009, 14:15
|
|
|
חבר מתאריך: 24.01.05
הודעות: 2,118
|
|
אני לא מכיר את הנושא ומאוד יכול להיות שלא הבנתי משהו, אבל אני מנסה ללמוד.
לפי החומר שמצאתי באינטרנט תפקיד של RC, כפי שכתבת, למנוע קפיצות מתח במקרה של עומס ובנוסף גם להבטיח סגירה בסיום חצי מחזור.
מתוך וויקי (כן, אני יודע שלא תמיד אפשר לסמוך על הכתבות, אבל זה הסבר יחיד שמצאתי):
A snubber circuit (usually of the RC type) is often used between A1 and A2 to assist this turn-off. Snubber circuits are also used to prevent premature triggering, caused for example by voltage spikes in the mains supply. Also, a gate resistor or capacitor (or both in parallel) may be connected between gate and A1 to further prevent false triggering. That, however, increases the required trigger current and / or adds latency (capacitor charging).
ושוב, אני לא נכנס לויכוח, אלא רק רוצה להבין ולסדר את הדברים בראש.
|